CCPPL - PRO-TECH SEMI GLOSS ENAMEL, WHT, 4600

  • MSDS: CCPPL
  • Manufacturer: SINCLAIR PAINT CO
  • Product Name: PRO-TECH SEMI GLOSS ENAMEL, WHT, 4600
  • National Stock Number: 8010-00N050354
Product Identification

Product ID:PRO-TECH SEMI GLOSS ENAMEL, WHT, 4600
MSDS Date:06/21/1994
FSC:8010
NIIN:00N050354
MSDS Number: CCPPL

Responsible Party
SINCLAIR PAINT CO
6108 SOUTH GARFIELD AVE
LOS ANGELES, CA 90040
US

Emergency Phone: 800-424-9300 (CHEMTREC)

Info Phone: 213-664-2121

Preparer: J G PRINZ

Cage: 0U0K0

Contractor
SINCLAIR PAINT COMPANY
LOS ANGELES, CA 90040 US

Telephone: 213-888-8888

Cage: 0U0K0

Ingredients

0.2 @ 68F

CAS: 57-55-6

RTECS: TY2000000

Fraction By Weight: <5%

OSHA PEL N/K

ACGIH TLV: N/K


1.54 LB/GL (185 G/L).

RTECS: 9999999VO

OSHA PEL N/K

ACGIH TLV: N/K

Hazards

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE:MAY CAUSE IRRITATION TO SKIN,
EYES, AND INTESTINAL SYSTEM. INHALATION:ADVERSE HEALTH EFTS FROM
VAPORS/SPRAY MISTS IN POORLY VENTILATED AREAS MAY INCLUDE
IRRITATION OF MUCOUS MEMBRANES OF NOSE, T HROAT, & RESPIRATORY
TRACT & SYMPS OF HEADACHE & NAUSEA. EYES:INDIRECT CONTACT MAY CAUSE
IRRITATION. (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:HLTH HAZ:SKIN ABSORP:REDNESS, DRYING OF SKIN,
OR OTHER SIGNS OF IRRITATION OR CONTACT DERMATITIS. INGESTION:CAN
CAUSE GASTROINTESTINAL IRRITATION, NAUSEA, VOMITING, & DIARRHEA.
CHRONIC:NONE LISTED BY MANUFACTURER.
Medical Cond Aggravated by Exposure:NONE.

First Aid

First Aid:SKIN:CLEANSE THOROUGHLY WITH SOAP & WATER. REMOVE ALL
CONTAMINATED CLOTHING. EYES:FLUSH IMMEDIATELY W/LARGE AMTS OF WATER
FOR AT LEAST 15 MINUTES. TAKE TO PHYSICIAN FOR MEDICAL ATTENTION.
INHAL:REMOVE TO FRESH AIR. INGEST:DRINK 1-3 GLASSESOF WATER TO
DILUTE. DO NOT INDUCE VOMITING. CONSULT PHYSICIAN OR POISON CONTROL
CENTER IMMEDIATELY. TREAT SYMPTOMATICALLY.

Fire Fighting

Lower Limits:2.6%
Upper Limits:12.6%
Extinguishing Media:FOAM, CO*2, DRY CHEMICAL, WATER FOG.
Fire Fighting Procedures:USE NIOSH APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT . THIS IS A WATER-BASED COATING. WILL NOT SUPPORT
COMBUSTION.
Unusual Fire/Explosion Hazard:CLOSED CONTAINERS EXPOSED TO HIGH
TEMPERATURES MAY EXPLODE OR BURST DUE TO BUILD UP OF STEAM
PRESSURE.

Accidental Release

Spill Release Procedures:DIKE, CONTAIN, OR ABSORB W/INERT MATERIAL
(I.E., SAND, VERMICULATE, ETC.). TRANSFER TO CONTAINERS FOR
RECOVERY OR DISPOSAL. PREVENT RUNOFF INTO SEWERS, STREAMS, OR OTHER
BODIES OF WATER. SEE INGRED & HEALTH HAZARDS DATA SECTIONS.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling

Handling and Storage Precautions:DO NOT EXPOSE TO EXTREMES IN
TEMPERATURES. AVOID EXPOSURE TO HIGH TEMPERATURE. DO NOT ALLOW TO
FREEZE.
Other Precautions:DO NOT TAKE INTERNALLY. AVOID PROLONGED OR REPEATED
EXPOSURE TO LEVELS ABOVE TLV.

Exposure Controls

Respiratory Protection:NOT NORMALLY REQUIRED. IF TLV IS EXCEEDED USE
NIOSH APPROVED ORGANIC VAPOR AND MIST PROTECTION.
Ventilation:USE ADEQUATE MECHANICAL (GENERAL AND/OR LOCAL) VENTILATION
TO MAINTAIN EXPOSURE BELOW TLV.
Protective Gloves:RESIST POLYETHYLENE GLOVES.
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:WEAR IMPERVIOUS CLOTHING. ANSI APPRVD EYE
WASH & DELUGE SHOWER .
Work Hygienic Practices:WASH HANDS BEFORE EATING OR USING RESTROOM.
REMOVE AND WASH CONTAMINATED CLOTHING BEFORE REUSE.
Supplemental Safety and Health
NONE SPECIFIED BY MANUFACTURER.

Chemical Properties

Boiling Pt:B.P. Text:212F,100C
Vapor Pres:SEE ING
Vapor Density:LTR/AIR
Spec Gravity:1.3 (H*2O=1)
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:COMPLETELY
Appearance and Odor:TYPICAL FOR WATER BASED LATEX COATING.

Stability

Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:NONE.
Hazardous Decomposition Products:MAY FORM TOXIC MATERIALS, CARBON
DIOXIDE, CARBON MONOXIDE, ETC.

Disposal

Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH ALL LOCAL, STATE,
OR FEDERAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.